Quote:
Originally Posted by zeus6631
I don't have tools to bend metal so thats out of the question. any thoughts?
|
Everyone has tools to bend sheet metal 
Get a flat piece of aluminum or steel, cut it to size. Then to bend it to the angle you want, draw a line where you want the bend. Take a 2x4 or any strong, straight piece of wood and at least 2 C-clamps, and sandwich the flat plate between the 2x4 and the edge of a table right on the line you drew. Now press down on the flat plate till you have the angle you want. It's easier to start small and work your way up, so do it a little at a time.  If need be, use a mallet to tap the plate to get the angle you want.
__________________
 '05 CCSB D/A LLY- V2 w/fan, Fan Damn Max, 45 gal Transfer Flow replacement tank, multiple gun racks, B&W turn over gooseneck hitch, Curt class 4 receiver hitch, cranked T-bars, 2" GM rear spacers, Rancho RSX9000, BFG All-Terrain T/A 285/70-17 on Hummer H2 wheels, Added 2nd generator, 2 sets of train horns, plus a bunch of other stuff.
'94 Yamaha V-Max, '99 Ducati 996s, '07 Yamaha FZ1
'05 Desert Fox 28ks toy hauler- 12' 9" tall 102" wide Total Combined Weight 21,700# 
It only took 5 minutes.....  
RIP Grizz. It was a fun hour and a half 
|
12-08-2009, 06:28 PM
Linear Mode
